Programming / Service software for the Motorola Radius GM300
It has been pointed out to me that this software only works with the GM300 so I have adjusted the page.
After searching for the genuine Motorola program I came across Motorola Radius GM300 Radio Doctor. This program runs fine under Windows XP and will do all the functions that the genuine Motorola radio service software does. Here is the main screen.
See a video of the software in use Rosetta stone 3 crack activation xp.
GM360 Professional Mobile Radio. Please read pages 55 to 58 before using this radio. RADIO CONTROLS The numbers below refer to the illustrations on the inside front cover. On-Off / Volume Knob Used to turn the radio on or off, and to adjust the radio’s volume. LED Indicators Indicates channel, scan, and monitor status, as. With this dynamic evolution of MOTOTRBO digital mobile two-way radios, you’re better connected, safer and more productive. The DM4000e Series is designed for the skilled professional who refuses to compromise.
Hanry on Kirisun PT568 Radio Programming Software Alain on Kenwood TKR-D710 VHF & TKR-D810 Basic Repeater Programming Guide David on Complete Motorola CPS 2.0 Upgrade Guide. The Motorola CP476, a quick start communication tool that is easy on the pocket and also comes with a wide range of accessories giving you operational efficiency with Motorola renowned reliability. Features include: Multi-channel capability— 45 channels (40 CB channels and 5 user programmable channels (450-480MHZ)) to support communication.
If you want a copy of Motorola Doctor software just join the following group
You will also need a simple interface to connect the radio to your PC. You can make your own or just search on Ebay for 'GM300 programming' or make programming interface from below 'at your own risk'
GM300 programming connection When looking at the radio here are the numbers
As you can see to make the programming interface for your GM300 is very basic.
Intel desktop board dh61cr driver for mac. Connection your Motorola GM300 for Echolink or IRLP etc.
If you want to use the COS/COR output from your GM300 the COS/COR on pin 8 is (active low). Many interfaces need a COS/COR input that is (active high) at 2 to 5vdc. You can make up a circuit to convert the output from pin 8 or take a COS/COR output from inside the radio that will give you a (active high) output. You will need to access the logic board on the underside of the radio. Remove the front of radio and the bottom cover and lift off the RF shield. See photo below.
Motorola Gm360 Programming Software User Manual Template
If you use thin wire you will be able to feed this out the edge of the 16 way connector. I tied a knot round the connector on the board to stop it being pulled off the board. Take care not to short this COS/COR out because it will damage the radio.